FESP 5132 Radiating Loop Antenna (0-150k)-Century Wisdom (Suzhou) Testing Technology Co., Ltd

English

Home page

Product

EMC Testing Solution Provider

FESP 5132 Radiating Loop Antenna (0-150k)

Brand:

SCHWARZBECK

FESP 5132 Radiating Loop Antenna (0-150k)

Product Description
Main features
Technical parameters

- Commodity name: FESP 5132 Radiating Loop Antenna (0-150k)
- Commodity ID: 1064722848347213824
- 品牌11: SCHWARZBECK
- 描述: FESP 5132 is mainly used for anti-interference testing of magnetic fields and conforms to the standards EN 55103 and MIL-STD-461 E.
- 品牌: SCHWARZBECK
FESP 5132 is mainly used in the anti-interference test of magnetic field, which complies with the standards EN 55103 and MIL-STD-461 E. Depending on the characteristics of the current source, magnetic fields of up to 1500 A/m can be generated in the short term. The magnetic field generated is proportional to the coil current. A spacer ring allows a precise distance of 50 mm between the coil and the EUT surface.
Main features :

FESP 5132 is mainly used in the anti-interference test of magnetic field, which complies with the standards EN 55103 and MIL-STD-461 E. Depending on the characteristics of the current source, magnetic fields of up to 1500 A/m can be generated in the short term. The magnetic field generated is proportional to the coil current. A spacer ring allows a precise distance of 50 mm between the coil and the EUT surface.

In some cases (requirements for moderate field strengths) a known series resistance can be used and the voltage across this resistance measured. A voltage reading conveniently obtained across a resistor which corresponds proportionally to the magnetic field produced. Larger series resistors have greater frequency dependence than inductors (but with reduced field strength efficiency).

The FESP 5132 can also be used to measure existing magnetic fields. The open circuit output voltage is directly proportional to the magnetic field strength (with constant frequency), or directly proportional to the frequency (with constant magnetic field strength). The output voltage of the FESP 5132 should be measured with a high-impedance device. If a 50Ω measuring device is used, the source impedance of the FESP 5132 must be considered for frequencies above 30 kHz (50 Ω at 100 kHz, 100 Ω at 200 kHz).

Frequency Range	0-150kHz
Coil Turns	20
wire diameter	2 mm Cu (AWG 12)
coil current	20 A (5 min.)
Nominal Coil Current	10 A continuous
Maximum magnetic field strength	1500 A/m, 5 minutes
Nominal magnetic field strength	750 A/m , continuous
Magnetic field strength, 1A coil current (50mm from the ring)	75.56 A/m (95 µT)
Current required for 1 A/m: (50mm from ring)	13.23 mA
Average Coil Diameter	120 mm
Empty coil center to measurement plane	50 mm
Mechanical Dimensions	0.16 m x 0.25 (0.3) m
Terminals: Banana Jacks	4 mm
inductance	80 H
resistance	0.3 Ω
weight	1.2 kg