Home page

CE106 (10kHz~40GHz antenna port conduction emission)

1. Introduction to the test

CE106 (10kHz~40GHz antenna port conducted emission) is suitable for antenna ports of transmitters, receivers and amplifiers, not suitable for devices whose antennas cannot be removed. For the equipment whose antenna cannot be disassembled, RS103 can be used instead of CE106 to test the transmitter and amplifier in the transmitting state, and RE102 can be used instead of CE106 to test the antenna emission of the receiver, transmitter and amplifier in the ready state.

The content about the emission state in this item does not apply to the EUT emission signal bandwidth or the frequency range of ±5% of the fundamental frequency (whichever is greater). The starting frequency of the test is determined according to the operating frequency range of the EUT. The upper limit frequency of the test is 40GHz or 20 times the highest transmit or receive frequency of the EUT, whichever is smaller. For equipment using waveguides, this item does not apply to frequency ranges below 0.8 times the waveguide cut-off frequency.

2. System connection diagram

(1) Low power test configuration

(2) High power test configuration

(3) Ready-to-send test configuration

3. Typical configuration

CE106 (10kHz~40GHz antenna terminal conducted emission)
serial number	product	illustrate	brand
1	ESW44	EMI fully compatible test receiver, frequency range 1Hz~44GHz	Rohde&Schwarz/Germany
2	DC set	Directional coupler kit, frequency range: 10kHz~40GHz	AR/ United States
3	TRF set	Suppression network kit, frequency range: 10kHz~40GHz	EMCO/ USA
4	SMA 100B	RF and microwave signal generator , frequency range: 8kHz~40GHz	Rohde&Schwarz/Germany
5	CE-TAB	CE test environment, including solid wood test table, insulation support, etc.	Century Huize/China

Century Wisdom (Suzhou) Testing Technology Co., Ltd

www.300.cn nanjing SEO

Business License

全部

全部
产品管理
新闻资讯
介绍内容
企业网点
常见问题
企业视频
企业图册