VVL1530 three-ring antenna-Century Wisdom (Suzhou) Testing Technology Co., Ltd

English

Home page

Product

EMC Testing Solution Provider

VVL1530 three-ring antenna

Brand:

AFJ

Product Description
Main features
Technical parameters

- Commodity name: VVL1530 three-ring antenna
- Commodity ID: 1064716576382144512
- 品牌11: AFJ
- 描述: This type of antenna is known as a Van Veen loop as defined in CISPR 16-1-4 and consists of three orthogonal loops that surround the platform on which the EUT is located.
- 品牌: AFJ
The CISPR 15 radiated EMI measurement frequency range of 9 kHz to 30 MHz is suitable for any luminaire that requires an interference voltage test and supplies luminaires at frequencies above 100 Hz. The test is performed inside a closed loop antenna with a diameter of 2m. This type of antenna is known as a Van Veen loop as defined in CISPR 16-1-4 and consists of three orthogonal loops that surround the platform where the EUT is located.

The VVL1530 is a calibrated 2-meter triple-loop antenna. It is designed and manufactured to meet the requirements of CISPR 15 and CISPR 16-1-4. The current probe around the inner conductor of each coaxial antenna cable has a sensitivity of 1V/A over the frequency range of 9kHz to 30MHz, so there is no need to use antenna coefficients during measurements. The calibration frequency range is from 9kHz to 30MHz.

The VVL1530 is a complete triaxial antenna with a manual switching unit that allows each loop to be selected in turn. The loop has a diameter of 2 meters, a minimum point of 0.5 meters above ground, and a specially designed current sensor in a fully shielded enclosure. Environmental interference is strongly suppressed in open area measurements.
main feature:

Current Probe with 1V/A Sensitivity, Frequency Range from 9kHz to 30MHz, No Antenna Factor Required

Three independent 2m loop antennas, easy to install and fully calibrated

Suitable for matching inductively coupled sensors

Switching the loop antenna manually with the selector

Low cost and can be used with any CISPR 16-1-1EMI receiver or spectrum analyzer

Optional Calibration Kit

Optional EUT bracket

No screws for easy storage

Ten minutes to assemble or disassemble

Technical Parameters:

design	Fully compliant with CISPR 15 and CISPR 16-1-4 standards
Frequency Range	9kHz-30MHz
loop antenna	3 independent loop antennas with a diameter of 2m, switch XYZ
Selector:	Use the panel switch to select and switch the loop antenna
output impedance	50Ω _
Connector	N famale
Operating temperature	0 ～45℃
Storage temperature	-20 ～70℃
size	2.6 x 2.1 x 2.1 m ( Height Z/Width X/Width Y)